This mount (hotend not included) is for installing a Slice
Engineering® Mosquito™ hotend or one of the clones (dragon or NF Crazy)
hotend, in place of the factory red hotend that comes on many Creality,
Creativity, SainSmart printers.
Key Features
-Minimal
Z axis Shift – The bottom of the nozzle only moves down about 3.5mm
with a Mosquito hotend and about 2mm with a Dragon hotend.
-No more groove mount – Your hotend is held rigid and will not rotate while changing nozzles.
-Light weight – This mount is only a couple grams, which will have minimal moving mass.
-Rigid – This billet aluminum mount is significantly stronger and more rigid than a printed plastic mount
-Drop
in solution for some printers, where you will not have to print any
parts to make it work. The new hotend will mount to the factory carriage
and fit inside the factory shroud with little to no modifications. (Elf
Corexy with Dragon, direct bolt on, Elf with Mosquito needs air guides
removed, Ender 3, Ender 5, CR-10 Mosquito fit perfectly under the
factory shroud on the printers we tested on).
-Flexible mounting
options – The mounting holes for the hotend are located every 45 degrees
so you have 8 possible mounting positions for your hotend.
-Piloted design to ensure a concentric filament path between the end of the PTFE guide tube and the entrance to the hotend.
A few of the printers this can fit
| Slice Engineering Mosquito
| Dragon Hotend
|
Creality Ender 3
| Mosquito Hardware Kit
| Creality - Dragon Hardware Kit
|
Creality Ender5 | Mosquito Hardware Kit
| Creality - Dragon Hardware Kit |
Creality Ender5 Pro
| Mosquito Hardware Kit | Creality - Dragon Hardware Kit |
Creality Ender 5 Plus | Mosquito Hardware Kit | Creality - Dragon Hardware Kit |
Creality Ender 6
| Mosquito Hardware Kit | Creality - Dragon Hardware Kit |
Creality CR-10
| Mosquito Hardware Kit | Creality - Dragon Hardware Kit |
SainSmart Coreception XY
| Mosquito Hardware Kit | Dragon Hardware Kit |
Koonovo Elf CoreXY | Mosquito Hardware Kit | Dragon Hardware Kit |
Creativity Elf CoreXY | Mosquito Hardware Kit | Dragon Hardware Kit |
This mount is ships with
1-Push to connect adapter fitting (installed)
Mosquito Hardware Kit Includes
2-M2X6mm screws for use with Mosquito style hotends
1- Ball End Hex Key
Dragon Hardware Kit Includes (Not required if you have the factory M2 screws for the groove mount adapter)
2-M2X5mm screws for use with Mosquito style hotends
2-M2 Washers (not typically needed, but included just in case)
1- Ball End Hex Key
Mosquito is a registered trademark of Slice Engineering