It's here - Pictures coming shortly
Cast Aluminum Printer Bed for Ender 3 S1 Printers
This bed incorporates the following features:
-CNC Machined, to ensure all features are exactly where they
-Premium cast aluminum plate, we only use MIC6, K100S, and ATP-5
cast plate to make our beds from.
-Machined perimeter - no raw saw cut edges, giving you a
nice finished appearance
-All holes are precisely sized and counterbores made exactly
the size they need to be.
-Build surface locating pins - When using a magnetic build
surface, out locating pins (screws) aid you to placing the removable build
surface, every time.
-Thermal Sensor groove milled into the top surface. This
positions the sensor as close as possible to the build surface, thereby giving
the best possible temperature reading.
-Thermal fuse and earth ground mounting locations – we provide
tapped holes to mount a thermal fuse and an earth ground lead, to facilitate the
safest installation possible.
-An additional 15mm on the back edge of the bed to allow for
attachment of cable clamps, cable drag chains. In this bed extension there are
3 sets of M3 holes 25mm apart for the clamps or drag chains to attach to.
-This bed supports mounting with four leveling screws, like
the factory configuration. Or three
point leveling, to match the West Coast Robotics carriage plate.
-Hardware included - We include the required hardware; New
M4 leveling screws, washers. Additionally we include the build surface backstop
pin (scews) and screws for mounting a thermal fuse and earth ground.
Printable area: 235mm x 235mm
Thickness: 6.35mm ¼”
Overall size: 235mm x 250mm
Flatness: Typically we see flatness less than 0.1mm
(0.004in), we check each bed to make sure it does not exceed 0.15mm (0.005)
This bed plate should fit the following printers
Ender 3 S1
Ender 3 S1 Pro
As delivered this is a bare cast aluminum bed that will
require you to provide a heater (if you want a heated bed) and a print surface
to print on. Most common heaters are either an adhesive silicone heater pad or
the factory heated bed. The factory heated bed sandwiched onto this bed plate
is the least ideal but has worked for some customers. For build surfaces the
most common is to use an adhesive bed-side magnet and spring steel plate
system, like the Wham-Bam system. Alternately you could apply an adhesive build
surface, like Build tack or PEI, directly to this bed.
These beds are made from cast aluminum tooling plate with
the top and bottom surfaces left untouched (mill finish). This means occasionally
there can be some small marks on the surface from material handling. Nothing
significant, but visually noticeable. This is just normal condition for the
material. We do everything we can to deliver a visually appealing product to
our customers but we can't prevent what happened before we buy our raw