Cast Aluminum Printer Bed for 300mm Voron Printers -
Trident, V2.4, V1.8
This bed incorporates the following features:
-Ultra Flat Build Surface - All of our beds are CMM measured for flatness before shipment, nothing over 0.100mm leaves as an Ultra Flat Bed
-CNC Machined, to ensure all features are exactly where they
-Premium cast aluminum plate, we only use MIC6, K100S, and ATP-5
cast plate to make our beds from.
-Machined perimeter - no raw saw cut edges, giving you a
nice finished appearance
-All holes are precisely sized and counterbores made exactly
the size they need to be.
-Build surface locating pins - When using a magnetic build
surface, out locating pins (screws) aid you to placing the removable build
surface, every time.
-Thermal Sensor groove milled into the top surface. This
positions the sensor as close as possible to the build surface, thereby giving
the best possible temperature reading.
-Thermal fuse and earth ground mounting locations – we provide
tapped holes to mount a thermal fuse and an earth ground lead, to facilitate the
safest installation possible.
-Hardware included - We include the required hardware the
build surface stop screws along with the thermal fuse and earth ground mounting
Printable Area: 304mm x 304mm
Thickness: 7.94mm 5/16”
Overall Size: X=304mm, Y=312
Flatness: Typically we see flatness between 0.022mm and 0.098mm, we check each bed on a CMM (coordinate measuring machine) to make sure it does not exceed 0.1mm (0.0039in)