Cast Aluminum Printer Bed for 350mm Voron Printers -
Trident, V2.4
This bed incorporates the following features:
-Ultra Flat Build Surface - All of our beds are CMM measured for flatness before shipment, nothing over 0.100mm leaves as an Ultra Flat Bed
-CNC Machined, to ensure all features are exactly where they
should be
-Premium cast aluminum plate, we only use MIC6, K100S, and ATP-5
cast plate to make our beds from.
-Machined perimeter - no raw saw cut edges, giving you a
nice finished appearance
-All holes are precisely sized and counterbores made exactly
the size they need to be.
-Build surface locating pins - When using a magnetic build
surface, out locating pins (screws) aid you to placing the removable build
surface, every time.
-Thermal Sensor groove milled into the top surface. This
positions the sensor as close as possible to the build surface, thereby giving
the best possible temperature reading.
-Thermal fuse and earth ground mounting locations – we provide
tapped holes to mount a thermal fuse and an earth ground lead, to facilitate the
safest installation possible.
-Hardware included - We include the required hardware the
build surface stop screws along with the thermal fuse and earth ground mounting
screws.
Specs
Printable Area: 355mm x 355mm
Thickness: 7.94mm 5/16”
Overall Size: X=355mm, Y=363
Flatness: Typically we see flatness between 0.022mm and 0.098mm, we check each bed on a CMM (coordinate measuring machine) to make sure it does not exceed 0.1mm (0.0039in)
Magnet Versions
****Beds with built in magnets are assembled to order and have a minimum of one week processing time****
****Beds with built in magnets must ship with a GROUND transportation shipping service, if you do not pick a ground service your order will be adjusted and you will be invoiced if there is a price difference****
Cast Aluminum Printer Bed for 350mm Voron Printers - Trident, V2.4
This bed incorporates the following features:
-Flat Build Surface - All of our beds are CMM measured for flatness before shipment
-CNC Machined, to ensure all features are exactly where they should be
-Premium cast aluminum plate, we only use MIC6, K100S, and ATP-5 cast plate to make our beds from.
-Machined perimeter - no raw saw cut edges, giving you a nice finished appearance
-All holes are precisely sized and counterbores made exactly the size they need to be.
-Build surface locating pins - When using a magnetic build surface, out locating pins (screws) aid you to placing the removable build surface, every time.
-Thermal Sensor groove milled into the top surface. This positions the sensor as close as possible to the build surface, thereby giving the best possible temperature reading.
-Thermal fuse and earth ground mounting locations – we provide tapped holes to mount a thermal fuse and an earth ground lead, to facilitate the safest installation possible.
-Hardware included - We include the required hardware the build surface stop screws along with the thermal fuse and earth ground mounting screws.
-25 samarium cobalt magnets, placed in the top surface flush or just barely below flush with the top surface. With 3lbs of pull each and a temp rating up to 300*C. These beds are made to order and have about a one week processing time.
Specs
Printable Area: 355mm x 355mm
Thickness: 7.94mm 5/16”
Overall Size: X=355mm, Y=363
Flatness: Total deviation from flat does not exceed 0.1mm. Every bed is checked on our CMM (coordinate measuring machine).
