Cast Aluminum Printer Bed for 350mm Voron Printers -
Trident, V2.4
This bed incorporates the following features:
-Flat Build Surface - All of our beds are CMM measured for flatness before shipment
-CNC Machined, to ensure all features are exactly where they
should be
-Premium cast aluminum plate, we only use MIC6, K100S, and ATP-5
cast plate to make our beds from.
-Machined perimeter - no raw saw cut edges, giving you a
nice finished appearance
-All holes are precisely sized and counterbores made exactly
the size they need to be.
-Build surface locating pins - When using a magnetic build
surface, out locating pins (screws) aid you to placing the removable build
surface, every time.
-Thermal Sensor groove milled into the top surface. This
positions the sensor as close as possible to the build surface, thereby giving
the best possible temperature reading.
-Thermal fuse and earth ground mounting locations – we provide
tapped holes to mount a thermal fuse and an earth ground lead, to facilitate the
safest installation possible.
-Hardware included - We include the required hardware the
build surface stop screws along with the thermal fuse and earth ground mounting
screws.
Specs
Printable Area: 355mm x 355mm
Thickness: 7.94mm 5/16”
Overall Size: X=355mm, Y=363
Flatness: total deviation from flat does not exceed 0.12mm. Every bed is checked on our CMM (coordinate measuring machine).
Magnet Versions
****Beds with built in magnets are assembled to order and have a minimum of one week processing time****
****Beds with built in magnets must ship with a GROUND transportation shipping service, if you do not pick a ground service your order will be adjusted and you will be invoiced if there is a price difference****
-25 samarium cobalt magnets, placed in the top surface flush or just barely below flush with the top surface. With 3lbs of pull each and a temp rating up to 300*C. These beds are made to order and have about a one week processing time.
-No need for a adhesive magnet sheet
-Typically the same weight or lighter than a our bed plus a 1mm adhesive magnet sheet
-Magnet beds do not hold the spring steel print surface plate as well as an adhesive magnet sheet, this is mainly because you are holding smooth metal on smooth metal versus smooth metal onto a grippy plastic surface
-We recommend using a spring steel sheet as thick as possible, 0.5mm or thicker and only use steel. There are some magnetic stainless steel sheets out on the market and they do not hold well
-The use of double sides spring steel sheets is not recommended as it reduces the magnetic pull and reduces the friction between the steel sheet and the printer bed.
-Our magnets are held in with a combination of adhesive and a screw. Both the screw and the magnet are not removable, it will rip the threads out of the bed and we will not offer refunds for this
Specs
Printable Area: 355mm x 355mm
Thickness: 7.94mm 5/16”
Overall Size: X=355mm, Y=363
Flatness: Typically we see flatness between 0.022mm and 0.098mm, we check each bed on a CMM (coordinate measuring machine) to make sure it does not exceed 0.15mm flatness
